![]() |
|
Products > Lighting and Electrical > Motogadget M-Flash Flasher relay
Motogadget M-Flash Flasher relay
Global innovation: The m-Flash digital flasher unit from motogadget
· Ultra small and light, only one cable with a tiny device the size of a piece of candy for all intents and purposes · Ideal for custom bikes and modifications with limited space - no clumsy standard flasher relay · Can be routed e.g. in handle bar, frame tubing or in the cable harness · Fully load-independent - constant and correct flashing rate always · Thus suitable for all LED blinkers, micro-blinkers, 10 watt blinkers, 21 watt blinkers, etc. · No load resistance or similar meaningless accessories required · Works with e.g. 4 signal lights or 2 handlebar end blinkers, etc. · Immediate, lossless blinker response · Super easy connection via two cables only - simply connect in series · Absolutely watertight · Short circuit proof, automatic overload protection · Generates no heat during operation · Operating voltage 5V to 18V · Also suitable for 6V blinkers Dimensions: Casing L x W x H: 18 mm x 13 mm x 9,.5 mm Connecting cable length: approx. 2 x 50 mm Weight: approx. 4 g Notes due to many inquiries: a) The m-Flash replaces a conventional flasher relay. This flasher relay normally sits BEFORE the blinker switch viewed in the circuit. If the m-Flash is also used BEFORE the flasher switch, you need only ONE m-Flash. You would only need two m-Flashes if used AFTER the flasher switch. Thus one module for each flasher circuit (left/right). Of course, this is also possible. Please compare to the following circuit diagram. The easiest option to install the m-Flash is to find the original relay and simply replace it with the m-Flash. b) The m-Flash cannot replace the button control when using pure push button controls.
|
All prices shown are in UK Pounds Sterling (GBP) and do not include 20% VAT payable on UK/EU orders. Copyright ©2012 Adrenalin-Moto Ltd. All Rights Reserved. |